Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Chart A-7A, Fuel System Diagnosis (Fuel Pump Relay Check): Notes
When ignition is turned on, ECM energizes fuel pump relay for 3 seconds, allowing fuel pump operation. When fuel pump relay is de-energized, fuel pump stops operating. If engine is being cranked or is running, fuel pump will continue to operate as long as ECM is receiving ignition reference pulses. If ignition reference pulses are not detected, fuel pump will stop after 3 seconds.
- Verifies fuel pump operation with ignition on.
- Checks fuel pump relay switch for power.
- This checks for faulty ECM or improper fuel pressure.
- Checks fuel pump circuit.
- Checks for open in Pink/Black wire.
- Checks for power at fuel pump relay coil.
- Checks for a faulty fuel pump or an open in Black wire.
- Checks for faulty fuel pump relay.
- Checks for faulty ECM and an open in Pink wire.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
