Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Geo Tracker Base, RWDFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Miscellaneous
MISCELLANEOUS LOCATION
| Component | Location | |
|---|---|---|
| A/C Amplifier | Behind right side of dash, on evaporator. See Figure . | |
| A/C-Heater Blower Resistor | At bottom of A/C-heater blower motor housing. See Figure . | |
| Daytime Running Light Resistor | Inside right front fender, above wheel well. | |
| Diagnostic/Check Connectors | ||
| ABS | Under left side of dash, near fuse block. | |
| ALDL | Under left side of dash, near fuse block. See Figure . | |
| Duty Check Coupler | On right side of engine compartment, near fusible link box. See Figure . | |
| Evaporator Thermistor | Behind right side of dash, in evaporator housing. See Figure . | |
| Noise Suppressor Condenser | On ignition coil bracket. See Figure . | |
| Noise Suppressor Filter | On left side of firewall, below wiper motor. See Figure . | |
| Shift Lock Diode (A/T) | Behind dash, left of steering column. | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.