Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Wheel Speed Sensor
The 2-wire rear wheel speed sensor is mounted in the rear differential carrier. Sensor transmits wheel speed information to the RWAL EBCM. This low AC voltage signal is generated through magnetic induction when a toothed exciter ring inside the differential passes the stationary magnetic coil of the sensor. This voltage signal increases in both frequency and amplitude as rear wheel speed increases.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.