Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code 23, Intake Air Temp (IAT) Sensor CKT, Low Temp Indicated: Notes
IAT sensor uses a thermistor to control signal voltage to ECM. ECM applies 4-6 volts on Blue/Black wire to sensor. When intake manifold air is cold, the sensor (thermistor) resistance is high and ECM senses a high voltage. As intake air warms, sensor resistance drops, and voltage drops.
- This checks if Code 23 is due to a hard failure or an intermittent condition. Code 23 is set if engine is running longer than 2 minutes and signal voltage indicates IAT temperature is less than -22Β°F (-30Β°C).
- Simulates conditions for a Code 23 (high temperature indicated). If scan tester displays a high temperature, ECM and wiring are okay.
- Checks continuity of Blue/Black and Black wires. If Black wire is open, Code 21 may also be present.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
