1992 Geo Prizm Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Code 41, Throttle Position Sensor (TPS), Open Or Short CKT: Notes

TPS provides a voltage signal that changes relative to throttle valve position. Signal voltage will vary from less than .6 volt at idle to about 4.5 volts at Wide Open Throttle (WOT).

The idle switch provides the ECM with information used to decide closed loop operation and indicates the off-idle condition to ECM. This switch is normally closed at idle and opens at engine speed greater than 1800 RPM, which is then the off-idle condition.

TPS signal is one of the most important inputs used by the ECM for fuel control and for many of the ECM controlled outputs.

NOTE: Test numbers refer to test numbers on diagnostic chart.
  1. Checks for 5-volt reference from ECM.
  2. Checks for ground to TPS.
  3. Checks for misadjusted TPS or for a faulty ECM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.