Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code 22, Coolant Temperature Sensor, Open Or Shorted Circuit: Notes
The Coolant Temperature Sensor (CTS) uses a thermistor to control signal voltage to ECM. ECM applies voltage on White wire to the sensor. When engine is cold, thermistor resistance is high. ECM will sense high signal voltage.
As engine warms, thermistor resistance decreases. ECM will sense low signal voltage. When engine reaches normal operating temperature, signal voltage will be about 1.5-2.0 volts at ECM.
- Verifies 4-5 volts is present at CTS connector.
- Checks ground side of CTS circuit.
- Determines if problem is caused by an open Brown wire or the ECM. Ensure ECM connectors fit properly.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
