Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code 15, Coolant Temp Sensor (Cts) CKT, High Temp Indicated: Notes
The coolant temperature sensor is a thermistor in series with a fixed resistor in the ECM. The ECM applies 5 volts to sensor. ECM monitors voltage across the CTS and converts it into a temperature reading. When engine is cold, CTS resistance is high. When engine is warm, CTS resistance is low. Therefore, when engine is cold, ECM receives a high voltage input and when engine is warm, ECM receives a low voltage input.
Code 15 will set if the following condition is met for at least 3 seconds:
- Voltage input at ECM indicates a coolant temperature of greater than 276Β°F (136Β°C).NOTE: Test number refers to number on diagnostic chart.
- This test simulates Code 14. If ECM sets Code 14, ECM and its wiring are okay and CTS is faulty. If Code 15 resets, CTS is okay and the wiring to ECM or the ECM is faulty.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
