Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Geo Metro L3-61 1.0LFACTORY OEM SERVICE PROCEDURE
Electronic/Powertrain Control Module (ECM/PCM)
ECM Wiring Diagram:
A23 = FUEL PUMP RELAY CONTROL
A19 = THROTTLE POSITION OUTPUT CONTROL
A5 = THROTTLE POSITION OUTPUT CONTROL
A18 = THROTTLE POSITION OUTPUT CONTROL
B11 = RD2L SIGNAL
A12 = FUEL INJECTOR CONTROL
A6 = UPSHIFT INDICATOR CONTROL
A8 = CHECK ENGINE INDICATOR CONTROL
A13 = IGNITION COIL CONTROL
A16 = DIAGNOSTIC REQUEST SIGNAL
A21 = DUTY CHECK OUTPUT
A3 = TEST SWITCH SIGNAL
A25 = ECM GROUND
A26 = ECM GROUND
A14 = MEMORY POWER INPUT
B3 = ELECTRICAL LOAD IDLE-UP SIGNAL
A4 = CRANK SIGNAL
ECM Wiring Diagram:
B7 = FUEL PUMP RELAY CONTROL
A15 = MAP INPUT
B8 = 5 VOLT REFERENCE
B14 = THROTTLE POSITION INPUT
B2 = IDLE SWITCH SIGNAL
B15 = COOLANT TEMPERATURE INPUT
B12 = SERIAL DATA OUTPUT
B16 = IAT INPUT
B6 = EXHAUST OXYGEN CONCENTRATION INPUT
A2 = OXYGEN SENSOR GROUND
B10 = VEHICLE SPEED INPUT
B1 = IGNITION REFERENCE HIGH
B9 = IGNITION REFERENCE LOW
A10 = ISC SOLENOID VALVE CONTROL
A9 = EGR VSV CONTROL
A1 = IGNITION POWER INPUT
B4 = A/C IDLE-UP SIGNAL
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
