1992 Geo Metro L3-61 1.0LFACTORY OEM SERVICE PROCEDURE

Throttle Position Sensor: Testing and Inspection

Throttle Position Sensor Check:

Factory service manual diagram



Throttle Position Sensor Output Check:

Factory service manual diagram





1. Remove air cleaner assembly.
2. Disconnect throttle position sensor electrical connector.
3. Using a digital multimeter, check throttle position sensor resistances (refer to the illustrations).
4. Adjust or replace according to procedure.
5. Install throttle position sensor electrical connector.
6. Install air cleaner assembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.