Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Geo Metro L3-61 1.0LFACTORY OEM SERVICE PROCEDURE
Throttle Position Sensor: Adjustments
Throttle Position Sensor Check:
Throttle Lever Stop Screw:
Throttle Position Sensor:
PROCEDURE
1. Connect a digital multimeter to throttle position sensor terminal "1" to terminal "2" and measure resistance.
2. Insert 0.3 mm (0.12") feeler gage between throttle stop screw and throttle lever.
3. With retaining screws loosely installed, turn throttle position sensor fully clockwise, then slowly counterclockwise just until digital multimeter indicates "0" ohms (continuity, switch closed). Tighten retaining screws to 2.0 Nm (18 lb in).
4. Remove feeler gage. Digital multimeter should still indicate "0" ohms (continuity, switch closed).
5. Insert 0.9 mm (0.035") feeler gage between throttle stop screw and throttle lever. Digital multimeter should now indicate an open circuit (no continuity, switch open).
6. Connect throttle position sensor electrical connector.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
