Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Check Engine Light: Notes
All vehicles are equipped with a CHECK ENGINE light, located on the instrument panel. The light will illuminate when the ignition switch is turned to the ON position (bulb check) and engine is not running. Light should not flash at this time and should go out when engine is started.
When the CHECK ENGINE engine light remains on or flashes, with the engine running, the self-diagnostic system has detected a problem. If the problem goes away, the light will go out after 10 seconds, but a trouble code will remain stored in the ECM memory.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.