Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Geo Tracker Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Current Output Test
- Turn ignition switch to OFF position. Disconnect negative battery cable. Disconnect alternator output wire from terminal "B". See Fig 1. Using an ammeter, connect positive ammeter lead to terminal "B" and negative lead to disconnected alternator output wire.
- Using a voltmeter, connect positive voltmeter lead to alternator terminal "B" and negative lead to ground. Install tachometer. Connect negative battery cable. Start engine. Turn headlights on high beam and heater switch on HIGH. Increase engine speed to 2000 RPM and note maximum current output on ammeter.
- If maximum current output is within 10 amps of rated amp output (55 amps) and voltmeter reading is 13.5-16.0 volts, alternator is okay. If maximum current output is not within 10 amps of rated amp output and voltmeter reading is less than 13.5 volts, repair or replace alternator.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
