Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Geo Tracker Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Alternator Output Test
To avoid a battery explosion, ensure carbon pile rheostat is OFF before connecting to battery.
- Mount alternator on test stand. Ensure ground polarity of alternator and battery are the same. Connect alternator to a fully charged 12-volt battery. Connect voltmeter, ammeter, carbon pile (in OFF position) and 10-ohm resistor (rated at 6 watts or more) between battery and alternator terminal IG. See Fig 1.
- Slowly increase alternator speed and observe voltmeter reading. If voltage is less than 16 volts, go to step 3). If voltage is uncontrolled and increases to more than 16 volts, rotor field is shorted and/or voltage regulator is defective. See VOLTAGE REGULATOR TEST in this article. A shorted rotor field can cause voltage regulator to become defective.
- If voltage is less than 16 volts, increase speed and adjust carbon pile as required to obtain maximum amperage output. Maintain voltage at 13 volts. If maximum output is within 10 amps of rated output (55 amps), alternator is okay. If maximum output is not within 10 amps of rated output, repair or replace alternator.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
