Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Geo Tracker Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Base Timing
- Inspect timing indicator mark and crankshaft pulley notch. Clean marks if necessary. See Figure . Start and warm engine to normal operating temperature. Ensure idle speed is within specification. See IDLE SPEED SPECIFICATIONS table. Turn off engine and all accessories. Attach timing light to No. 1 spark plug wire.
- Start engine and aim timing light at crankshaft pulley. If timing is not within specification, loosen distributor flange hold-down bolt and rotate distributor to obtain correct ignition timing. See IGNITION TIMING SPECIFICATIONS table. Tighten distributor flange hold-down bolt to 11 ft. lbs. (15 N.m) and recheck timing.
IGNITION TIMING SPECIFICATIONS (Degrees BTDC @ RPM)
| Application | Man. Trans. | (1) Auto. Trans. | ||
|---|---|---|---|---|
| Tracker | 8 @ 800 | 8 @ 800 | ||
|
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.