Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code 23B, Manifold Air Temperature (Mat) Sensor Circuit High Temperature Indicated: Notes
The MAT sensor uses a thermistor to control the signal voltage to the ECM. The ECM applies 4-6 volts on Purple/Black wire to sensor. When manifold air is cold, the sensor (thermistor) resistance is high and the ECM sees a high voltage. As the air warms, the sensor resistance becomes less and the voltage drops.
- This checks if Code 23B result from a hard failure or an intermittent condition. Code 23B sets if MAT temperature greater than 293°F (145°C) is detected for a time longer than 2 seconds.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.