1990 Geo Storm Base, StandardFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES LOCATION

Component Location
A/C Dual Pressure Switch Mounted on top of receiver-drier. See Figure .
A/C Thermostatic Switch Attached to evaporator core. See Figure .
Back-Up Light Switch On top left side of transaxle. See Figure .
Clutch/Start Switch On clutch pedal bracket.
Fan Switch On front of engine, near CTS. See Figure & 2.
Gear Switches On lower left side of transaxle. See Figure .
Kickdown Switch (Auto. Trans.) On accelerator pedal bracket.
Oil Pressure Switch On right side of engine block, above starter.
Park/Neutral Switch On left side of transaxle case. See Figure & 2.
Parking Brake Switch On base of parking brake lever.
Power Steering Pressure Switch Mounted in and part of power steering pump. See Figure & 2.
Stoplight Switch On brake pedal bracket.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.