1990 Geo Prizm Base, 4D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE

Engine Backfires

If fuel ignites in intake manifold or exhaust system and makes a loud popping noise, check the following items:

  • Ensure exhaust system is not leaking.
  • Check base timing and ensure timing advance system is functional.
  • Using Spark Tester (ST-125), check output of ignition coils.
  • Check for intake manifold gasket leak and TBI gasket-to-manifold leak.
  • Check for proper valve timing.
  • Check engine for sticking or leaky valves.
  • Check ECM and ignition system for faulty grounds.
  • Check throttle body dashpot adjustment (if equipped).
  • Check throttle position sensor.
  • Check coolant temperature sensor.
  • Check air valve, ISC solenoid and idle switch operation.
  • Check intake air system and throttle body electrical connections.
  • Ensure fuel system pressure is correct.
  • Check A/C vacuum solenoid valve (if equipped).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.