Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code 41, Throttle Position Sensor Open Or Shorted Circuit VIN 5): Notes
The Throttle Position Sensor (TPS) provides a voltage signal that changes relative to throttle valve angle. Signal voltage varies from less than .60 volt at idle to about 4.5 volts at Wide Open Throttle (WOT).
The TPS provides the ECM with information used to decide closed Loop operation and indicates the off-idle condition to the ECM. The TPS is normally closed at idle and opens when engine speed is greater than 1800 RPM, which is then the off-idle condition. TPS information is used by the ECM for fuel control and many other ECM controlled outputs.
- Voltage should be less than .6 volt at idle.
- Voltage should increase to greater than 4.5 volts at WOT.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
