Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Geo Metro LSi, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE
Code 24, Vehicle Speed Sensor Circuit: Notes
The ECM supplies a 12-volt signal to Vehicle Speed Sensor (VSS). The VSS toggles this signal (on-and-off) indicating vehicle is moving.
NOTE:
Test numbers refer to test numbers on diagnostic chart.
- If speedometer is inoperative, this could cause Code 24.
- This checks if ECM is supplying 12 volts to VSS.
- The VSS is on the back of the instrument panel. Code 24 will set if fuel remains cut for 4 seconds or longer, engine speed is less than 4000 RPM and less than one mile an hour is sensed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.