Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Geo Metro L3-61 1.0LFACTORY OEM SERVICE PROCEDURE
System Specifications
Vin 5, Bore Dimensions
| Cylinder Bore Diameter (Standard) Note: Cylinder bore diameter Nos. are stamped on the top of the block in sequence. | No.1 | 2.9138-2.9142 |
| No.2 | 2.9134-2.9138 | |
| Cylinder Bore Taper Maximum | 0.0039 | |
| Cylinder Bore Out Of Round Maximum | 0.0039 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.