Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Geo Metro L3-61 1.0LFACTORY OEM SERVICE PROCEDURE
Front Toe Adjustment
Fig. 2 Front Wheel Toe Adjustment:
1. Loosen right and left tie rod end locknuts, Fig. 2.
2. Apply grease between tie rods and rack boots.
3. Turn right and left tie rods by the same amount to align toe to specification. Right and left tie rods should become equal in length.
4. After adjustment, tighten locknuts and ensure rack boots are not twisted.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.