Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Geo Metro Base, 2D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE
Engine Compression
- Warm engine to normal operating temperature. Ensure battery is fully charged, remove spark plugs, block throttle wide open and disconnect ignition coil primary connector.
- Disconnect distributor and remove main relay fuse (15 amp) from engine compartment fuse box.
- Put transmission in Neutral (M/T) or Park (A/T). Attach compression gauge and crank engine until maximum compression is reached at each cylinder and record pressure. See COMPRESSION SPECIFICATIONS table.
COMPRESSION SPECIFICATIONS
| Application | Specification | ||
|---|---|---|---|
| Compression Ratio | 9.5:1 | ||
| Compression Pressure | (1) 156-199 psi 11.0-14.0 kg/cm2 ) | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.