Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Geo Tracker Base, StandardFACTORY OEM SERVICE PROCEDURE
Fuel Pressure Release (Metro)
- Place transmission in Neutral or Park and block drive wheels. Remove main fuse box cover and engine coolant reservoir from bracket. Remove main fuse box attaching screws.
- Disengage fuel pump relay from connector. Remove fuel tank filler cap. Start engine and idle until engine dies. Crank engine to ensure fuel is dissipated from system. Install fuel pump relay and replace fuel tank cap.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.