Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Geo Tracker Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Chart A-8, Control Relay Circuit Check
Control relay is involved in many of the circuit that ECM uses to control the starting of the vehicle. Fuel pump circuit and starter operation depends on function of control relay.
NOTE:
Test numbers refer to test numbers on diagnostic chart.
- Test checks on ignition side of control relay.
- Test checks ECM and fuel pump circuit.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.