Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Geo Tracker Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Plug Wire Resistance
HIGH TENSION WIRE RESISTANCE
| Application | Ohms | |||
|---|---|---|---|---|
| Metro & Prizm | 3000-6700 per Foot | |||
| Spectrum | ||||
| Plug wire No. 1 | 6440-15,030 | |||
| Plug wire No. 2 | 5290-12,340 | |||
| Plug wire No. 3 | 4810-11,200 | |||
| Plug wire No. 4 | 3350-7820 | |||
| Tracker | (1) | |||
|
||||
NOISE FILTER/SUPPRESSOR RESISTANCE
| Application | Ohms | ||
|---|---|---|---|
| Metro | 2200 | ||
| Tracker | (1) | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.