1989 Geo Tracker Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Removal (Tracker)

  1. Disconnect negative battery cable. Unplug TPS wiring harness coupler.
    NOTE: If TPS is being replaced, wiring may have to be removed from coupler. Note wire colors and placement before removal.
  2. If wiring is being removed from coupler, unlock terminal locks and pull TPS wiring harness from coupler. See Fig 1 . Remove mounting bolts and remove TPS from throttle body.
Fig 1: Removing Tracker Throttle Position Sensor Terminals
G121765Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.