1989 Geo Spectrum L4-91.5 1.5LFACTORY OEM SERVICE PROCEDURE

Cruise Control: Testing and Inspection


Fig. 1 Cruise Control Diagnostic Procedure (Part 1 Of 4):

Factory service manual diagram



Fig. 1 Cruise Control Diagnostic Procedure (Part 2 Of 4):

Factory service manual diagram



Fig. 1 Cruise Control Diagnostic Procedure (Part 3 Of 4):

Factory service manual diagram



Fig. 1 Cruise Control Diagnostic Procedure (Part 4 Of 4):

Factory service manual diagram



Fig. 2 Cruise Control Wiring Circuit. Manual Transmission:

Factory service manual diagram



Fig. 3 Cruise Control Wiring Circuit. Automatic Transmission:

Factory service manual diagram





For cruise control system diagnosis, refer to Fig. 1 for diagnostic procedures and for cruise control electrical circuits and connector pin locations, refer to Figs. 2 and 3.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.