Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code 22, Fuel Cut-Off Relay Circuit Open Or Grounded
The fuel cut-off solenoid is energized by the fuel cut-off relay with ignition switch in the "ON" position. When ignition is turned off, the fuel cut-off solenoid is de-energized and fuel is immediately cut off to prevent dieseling. Using the signal from the idle switch, the ECM will shut off fuel when it senses a coasting condition after off-idle condition.
- This checks if Code 22 is intermittent.
- This determines if relay or ECM circuits are faulty.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
