Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Geo Metro BaseFACTORY OEM SERVICE PROCEDURE
Code 51, Exhaust Gas RECIRCULATION (EGR) Circuit CALIFORNIA Only): Notes
The EGR Vacuum Switching Valve (VSV) solenoid is controlled by the ECM. The VSV solenoid is supplied with battery voltage. The ECM completes the ground circuit to energize the VSV solenoid.
NOTE:
Test numbers refer to test numbers on diagnostic chart.
- This checks for a short to ground.
- This checks for voltage from main relay.
- This checks if code is faulty or ECM is faulty.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
