Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
CODE 41, IGNITION SIGNAL CIRCUIT NO SIGNAL LSi CONVENTIONAL IGNITION SYSTEM: Notes
This ignition system has a standard vacuum advance. The ignition system sends a signal to the ECM. The ECM uses this signal to determine when to pulse the fuel injector. Code 41 sets if the ECM does not receive a signal for 2 seconds.
- The ignition system sends an AC voltage that varies while engine is being cranked.
- This checks ECM and noise suppressor.
- This tests noise suppressor.
- This checks pick-up coil in distributor.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
