Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Genesis GV60 AdvancedFACTORY OEM SERVICE PROCEDURE
Technical Bulletins: Campaigns
- Battery Management Systems
- BMS Update For Cell Voltage Variance And Charging Interruption Prevention (Service Campaign T62G) (24-01-083G)
- DTC P1A9096 Check For ICCU & Fuse Replacement & ICCU Software Update (Recall 025G) (24-01-087G)
- VCMS Update Software - Charging Logic (Service Campaign 910G) (24-01-051G)
- DTC P1A9096 Check For ICCU & Fuse Replacement And ICCU Software Update (Service Campaign 907G) (23-01-069G-1)
- Brakes Control Systems
- Charging Systems
- Collision/Avoidance
- Electric Converters and Controllers
- Engine Control Systems
- Mirrors
- Starter
- Steering Column
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.