Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Genesis Electrified G80 AdvancedFACTORY OEM SERVICE PROCEDURE
Audio Video Navigation DTCS
AUDIO VIDEO NAVIGATION DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| B1030-00 | No Camera Tolerance Correction |
| B16B7-00 | Front Camera Input Error |
| B16B8-00 | Rear Camera Input Error |
| B16B9-00 | Left Camera Input Error |
| B16BA-00 | Right Camera Input Error |
| B2816-00 | Local-CAN Error |
| B2824-00 | FRT MIC Connection Error |
| B2826-00 | GPS Antenna Short State |
| B2827-00 | GPS Antenna Open State |
| B2835-00 | Phone Connectivity Service Failure |
| B2841-00 | USB Communication Error |
| B2843-00 | Multimedia Terminal Connection Error |
| B2848-00 | XM Antenna Short State |
| B2849-00 | XM Antenna Open State |
| B2861-00 | LVDS Front Cable Fault |
| B28C0-00 | Am/Fm1 Radio Antenna Short State |
| B28C1-00 | Am/Fm1 Radio Antenna Open State |
| B28C2-00 | FM2 Radio Antenna Short State |
| B28C3-00 | FM2 Radio Antenna Open State |
| B28C6-00 | LTE1/3G Antenna Short State |
| B28C7-00 | LTE1 Antenna Open State |
| B28C9-00 | LTE2 Antenna Short State |
| B28CA-00 | LTE2 Antenna Open State |
| B2949-00 | Radio Antenna Connection & Receive Quality |
| B29D0-00 | CCP Connection Error (Local-CAN) |
| B29D1-00 | RRC Connection Error (Local-CAN) |
| B29D5-00 | MKBD Connection Error (Local-CAN) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.