Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2023 Genesis G80 2.5T Advanced, AWDFACTORY OEM SERVICE PROCEDURE

ETC (Electronic Throttle Control) System: Specifications: Specification: Notes

Type: Hall IC non-connect sensor type

[TPS1]

Item	Duty (%)	Output Voltage (V) [Supply Voltage = 5V]
C.T	8.5-11.5%	0.43-0.58
W.O.T	88 - 96%	4.4-4.8

[TPS2]

Item	Duty (%)	Output Voltage (V) [Supply Voltage = 5V]
C.T	88.5-91.5 %	4.43-4.58.
W.O.T	2-10%	0.1-0.5

Courtesy of HYUNDAI MOTOR AMERICA

Chapter Navigation

Return to Chapter: Specification

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.