Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2023 Genesis Electrified G80FACTORY OEM SERVICE PROCEDURE
Power Trunk Module DTCS
POWER TRUNK MODULE DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| B1602-00 | CAN Line Error (B-CAN) |
| B1603-00 | CAN Bus OFF (B-CAN) |
| B24BA-00 | PTG Latch Cinching Rewinding Fail Max |
| B24BB-00 | PTG Integrated Latch Home Position Switch Error |
| B24D0-00 | Power Trunk Module Inline Mode Not Deactivated |
| B24D1-00 | PTL Unlatch Error |
| B24D2-00 | PTL Hall Sensor Error |
| B24F0-00 | PTG Integrated Latch Switch Combination Error |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.