Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2023 Genesis Electrified G80FACTORY OEM SERVICE PROCEDURE

Power Latch Assembly: Inspection

Remove the trunk lid trim.
(Refer to Body - "TRUNK LID TRIM ")
Disconnect the power latch and cinching connectors.

Courtesy of HYUNDAI MOTOR AMERICA
Connect the power latch terminals directly to battery voltage (12V) and check that the motor operates smoothly.

[Latch & Actuator]

Courtesy of HYUNDAI MOTOR AMERICA

Terminal	LOCK→ UNLOCK	UNLOCK LOCK→
4	+	X
3	-	X
1 & 2	OFF → ON	ON → OFF

[Cinching & Actuator]

Courtesy of HYUNDAI MOTOR AMERICA

Terminal	OPEN	OPEN → 1ST LOCK	1ST LOCK→ 2ND LOCK	2ND LOCK → RETURN	RETURN POSITION
2	X	-	-	+	X
1	X	+	+	-	X
4 & 3	ON	ON	ON	OFF	OFF
4 & 5	ON	ON → OFF	OFF	OFF	OFF
4 & 6	ON	ON	ON → OFF	OFF	OFF
7 & 8	ON	ON → OFF	OFF→ON→OFF	OFF	OFF

Terminal	CLOSE	CLOSE → OPEN	OPEN → RETURN	RETURN POSITION
2	X	+	-	X
1	X	-	+	X
4 & 3	OFF	ON	ON → OFF	OFF→ ON
4 & 5	OFF	OFF→ON	ON	ON
4 & 6	OFF	OFF→ON	ON	ON
7 & 8	OFF	OFF →ON	ON	ON

Chapter Navigation

Return to Chapter: Power Latch Assembly

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.