Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Genesis GV70 2.5TFACTORY OEM SERVICE PROCEDURE
Removal And Installation
NOTE:
- Install the component to the specified torques.
- If a part is dropped, replace it with a new one and discard the dropped part as invisible damage may be caused.
- Insert the sensor in the installation hole and be careful not to damage it.
- Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
- Remove the Engine Cover.
(Refer to Engine Mechanical System - "ENGINE COVER ")
- Disconnect the manifold absolute pressure sensor connector (A).
- Remove the installation bolts (B), and then remove the sensor from the intake manifold.
Tightening torque:
9.8 - 11.7 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.6 lb-ft)
- Install in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.