Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Genesis GV70 2.5TFACTORY OEM SERVICE PROCEDURE
Canister Close Valve (CCV): Inspection
- Turn the ignition switch OFF.
- Disconnected canister close valve connector.
- Measure resistance between the canister close valve terminals 1 and 2.
- Check that the resistance is within the specification.
Specification: 19.5 - 22.5 [20°C (68°F)]
- Disconnect the vapor hose connected with the canister from the CCV.
- Connect a vacuum pump to the nipple.
- Apply vacuum to the valve with the battery power (B +) applied.
Specification: Vacuum maintained
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.