2022 Genesis G80 2.5T Advanced, AWDFACTORY OEM SERVICE PROCEDURE

Description And Operation: Description

Ejector Pressure Sensor is installed on the air cleaner and controls the passage between the canister and the vacuum line. The evaporative gases gathered in the canister are delivered to the Intercooler outlet pipe when the Ejector Pressure Sensor is open by ECM control signal.

G15547358Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.