2022 Genesis G80 2.5T Advanced, AWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Switch "OFF" the ignition and disconnect the battery negative (-) terminal.
  2. Remove the rear left wheel & tire and wheel house cover.
  3. Disconnect the vent hose quick-connector (A).
    G15547462Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the installation bolts, and than remove the fuel tank air filter bracket (A).

    Tightening torque:Β 

    3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb.ft)

    G15547463Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the fuel tank air filter (A) by rotating it about 30Β°.
    G15547464Courtesy of HYUNDAI MOTOR AMERICA
  6. Disconnector the canister close valve connector (A).
    G15547465Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the Canister Close Valve (A) by rotating it about 30Β°.
    G15547466Courtesy of HYUNDAI MOTOR AMERICA
    G15547467Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.