Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Genesis GV80 2.5T Advanced, AWDFACTORY OEM SERVICE PROCEDURE
E-Shifter DTCS
E-SHIFTER DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| C1101-17 | Battery Voltage High |
| C1102-16 | Battery Voltage Low |
| C1112-62 | Power Signal Error |
| C1382-01 | Lever Hall Sensor Fault |
| C1533-64 | Park Switch Fault |
| C1535-64 | Park Release Switch Fault |
| C1537-94 | T/M Switch Fault |
| C1604-04 | ECU Hardware Error |
| C1612-87 | CAN Time-Out TCU |
| C1616-88 | C-CAN Bus Off |
| C1646-86 | CAN Message Failure - TCU |
| C183A-82 | CAN Message Failure - TCU (Alive Counter) |
| C183A-83 | CAN Message Failure - TCU (CRC) |
| C2241-02 | PRA (Park Release Actuator) Range Fault |
| C2242-01 | PRA (Park Release Actuator) Hall Sensor Fault |
| C2422-71 | Park Release Motor Fault |
| C2423-19 | Park Release Motor Gear Fault |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
