DTC Information And Inspection: DTC Detecting Condition

2021 Genesis GV80 2.5T Advanced, AWDSECTION DTC Detecting Condition
Item Detecting Condition Possible Cause
DTC Strategy
  • CAN message monitoring
  1. Faulty Automated Driving System Control Module "A"* power supply
  2. Ethernet "+" line open/poor contact
  3. Ethernet "-" line open/poor contact
  4. Short circuit between Ethernet "+" line and "-" line
  5. Faulty Automated Driving System Control Module "A"*
Enable Condition
  • Ignition "ON"
  • Power voltage: Between 9V and 16V
  • Ethernet communication: active
Threshold Value Not Communication
  • Data: not entered
Abnormal Data
  • Data: Abnormal data entered
Diagnostic Time
  • 2 seconds
Mil On Condition
  • 2 driving cycles*
Driving Cycle*: DC
  • When [Ignition ON β†’ Engine ON β†’ Ignition ON] is executed, one driving cycle* (1 DC) is completed
  • "MIL ON" means that the fault is confirmed as soon as a fault is detected during the first driving cycle* and "MIL ON" is output from the ECM*
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.