2021 Genesis GV80 2.5T Advanced, AWDFACTORY OEM SERVICE PROCEDURE

Component Function: Cluster: Function

The cluster module controls a variety of functions installed on a control panel including MIL, trip computer, cluster text warning display, USM*, and sounds by receiving information through CAN communication lines. It also functions the variant coding, which synchronizes the cluster settings with the vehicle's system specifications transmitted by GDS.

DTCs will set when the vehicle information from CAN BUS and that from EOL* do not correspond. On the assembly line, EOL communication will terminate if any DTC is not detected through DTC search. At the service field, the cluster setting must be completed through variant coding using GDS in order to synchronize the vehicle information on GDS with that on the cluster.

Component Name_ETM Description ETM
Cluster* "INSTRUMENT CLUSTER" Instrument Cluster SD200-11
4WD "4WD ECU" 4 Wheel Drive SD200-4
AFLS "HEAD LAMP LH" "HEAD LAMP RH" Adaptive Front Lighting System SD200-6
DSW camera
DSWECU
"INSTRUMENT CLUSTER" Driver State Warning system: The camera recognizes the driver's face in real time while driving and displays a warning message on the cluster in case of negligence in driving. SD200-11
ECS "ECS UNIT" Electronic Control Suspension SD200-2
IBU
BCM
TPMS
SMK
"IBU" β†’ [BCM+TPMS+SMK] Integrated Body control Unit
β†’ Body Control Module
β†’ Tire Pressure Monitoring System
β†’ SMart Key control module
SD200-4
SD200-6
IEB
ESC
ABS
EPB
"IEB UNIT"" β†’ [ABS+ESP+EPB] Integrated Electronic Booster control module
β†’ Electronic Stability Control
β†’ Anti-lock Braking System
β†’ Electronic Parking Brake
SD200-2
SD200-4
LKAS "LKAS UNIT" Lane Keeping Assist System SD200-8
MDPS "MDPS UNIT" Motor Driven Power Steering SD200-2
PSB "PRE-ACTIVE SEAT BELT UNIT" Pre-active Seat Belt SD200-6
SCC "SMART CRUISE CONTROL RADAR" Smart Cruise Control SD200-8
SRSCM "SRS CONTROL MODULE" Supplemental Restraints System Control Module SD200-2
TCU "TCM" Transmission Control Unit SD200-4
USM* User Setting Mode, "User Settings" in the cluster
EOL* End of Line
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.