Front View Camera Variant Coding

2021 Genesis GV80 2.5T Advanced, AWDSECTION Front View Camera Variant Coding

Front view camera variant coding makes it possible to operate functions for each vehicle type. If the variant coding differs from the vehicle specification, the "variant coding error" DTC is displayed.

  1. Procedure for coding variants
    1. You should read the specification information for the front view camera that is installed in the vehicle before replacing it with a new front view camera.
    2. Connect the cable of Diagnostic tool to the data link connector in driver side crash pad lower panel, and turn on the Diagnostic tool.
    3. Select the 'S/W Management' and 'Car model'.
      G14727614Courtesy of HYUNDAI MOTOR AMERICA
    4. Select "System Identification".
      G14727615Courtesy of HYUNDAI MOTOR AMERICA
      G14727616Courtesy of HYUNDAI MOTOR AMERICA
    5. Select "Variant Coding".
      G14727617Courtesy of HYUNDAI MOTOR AMERICA
    6. Enter the value of the specification read in procedure (4) in the new front view camera.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.