Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Repair Procedures: Inspection
If idle rpm is unstable or engine stops, check the ETC module operation with GDS diagnostic tool.
And if necessary, clean carbon in the throttle body.
- Connect the GDS to the Data Link Connector (DLC).
- Select "Vehicle S/W management" → "Inspection/Test" → "ETC Performance Test" on the GDS menu.
- Perform
"ETC module test" procedure in accordance with the message.
- If the test result of the ETC module or TPS signal shows NG, perform ETC module cleaning.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.