Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGENESIS2021G80 2.5T ADVANCED, AWDREPAIR AND DIAGNOSISSTEERINGSTEERING COLUMNSTEERING COLUMN MODULESTEERING COLUMN MODULE (SCM)REPAIR PROCEDURESREMOVAL AND INSTALLATIONSTEERING LIMIT POSITION SETTING
2021 Genesis G80 2.5T Advanced, AWD
Steering Limit Position Setting
2021 Genesis G80 2.5T Advanced, AWDSECTION Steering Limit Position Setting
NOTE:
- Steering Limit Position Setting is must be done when any of cases is met as listed below.
- After replacing SCM Unit.
- After replacing steering.
- SCM Error (Only 2 second movement while pressing SCM switch)
- Perform the steering limit position setting.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.