2021 Genesis G80 2.5T Advanced, AWDFACTORY OEM SERVICE PROCEDURE

Integrated Led Headlamp Control Unit_RH DTCS

INTEGRATED LED HEADLAMP CONTROL UNIT_RH DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION

DTC Description
B1101-17 Battery Voltage High
B1102-16 Battery Voltage Low
B1603-88 CAN BUS OFF
B1621-01 ECU hardware
B1622-48 ECU Software
B1636-88 LIN Error
B1637-54 System Not Initialized
B1661-46 Parameter Fault And Missing
B16F0-87 Lamp Control Signal Fault
B16F1-87 IFS Control signal fault
B16F3-87 Other Side ILCU signal fault
B1953-03 AXLE Sensor Fault
B2219-81 Module error IFS Board Left
B2220-81 Module error IFS Board Right
B2221-81 LIN error LIN-HLLD Left
B2222-81 LIN error LIN-HLLD Right
B2475-09 Module error LIN-HLLD Left
B2476-09 Module error LIN-HLLD Right
B2477-09 Fan Error
B24C4-09 LED Fault Low beam
B24C5-09 LED Fault High beam
B24C6-09 LED Fault T/Signal
B24C7-09 LED Fault DRL/PSTN
B24C8-09 LED Fault IFS
B24C9-09 LED Driver IC Fault
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.