2021 Genesis G80 2.5T Advanced, AWDFACTORY OEM SERVICE PROCEDURE

MPI Injector

WARNING: This page is about a different variant/trim than selected.
  1. Release the residual pressure in fuel line.

    (Refer to Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

    CAUTION:
    • When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the diagnostic tool after completion of "Release Residual Pressure in Fuel Line" work.
  2. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  3. Remove the engine cover.

    (Refer to Engine Mechanical System - "ENGINE COVER ")

  4. Remove the air cleaner.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  5. Remove the surge tank.

    (Refer to Engine Mechanical System - "SURGE TANK ")

  6. Remove the low pressure delivery pipe and then remove the intake manifold.

    (Refer to Engine Mechanical System - "INTAKE MANIFOLD ")

  7. Remove the mounting bolt (A).

    Tightening torque:Β 

    29.4 - 35.3 N.m (3.0 - 3.6 kgf.m, 21.7 - 26.0 lb-ft)

    G15557056Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the low pressure delivery pipe (B) after loosening the mounting bolts (A).
    NOTE:
    • When removing/installing the low pressure delivery pipe (A), take measures not to allow the foreign matter to enter the cylinder.
    • If foreign matter enters the cylinder/intake manifold, immediately remove it.
    G15557057Courtesy of HYUNDAI MOTOR AMERICA
    G15557058Courtesy of HYUNDAI MOTOR AMERICA
  9. Release the fixing clip and then remove the injector (A) from delivery pipe.
G15557059Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.