2021 Genesis G80 2.5T Advanced, AWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install in the reverse order of removal.
    NOTE:
    • When tightening the high pressure fuel pipe flange nut, use a special tool (09314-3V100) or a wrench torque wrench.
      G15557081Courtesy of HYUNDAI MOTOR AMERICA
      G15557082Courtesy of HYUNDAI MOTOR AMERICA
    • Do not reuse the used injector fixing clip.
    • Do not reuse the used high pressure fuel pipe.
    • Careful not to deform the high pressure fuel pipe shape.
    • Do not tilt the torque wrench when tightening the nut.
    • Observe the work order and tightening torque when assembling.
    • After assembly of the high pressure fuel pipe, check for leaks.
      1. Refer to the following when reusing the injector.

    [GDI Injector]Β 
    • When removing/reinstalling the injector, be careful not to allow the foreign substances to enter the cylinder.
    • If foreign substances has entered the cylinder/intake manifold, immediately remove them.
    • When removing/reinstalling the injector, clean the cylinder head hole (removal of carbon deposits using a brush).
    • Reinstall the injector after replacing/assembling the consumable parts among the injector components using the HDEV 6 tool set.
    • Remove the fixing ring when reinstalling the injector.
    • Be careful not to apply oil/grease/lubricant to the injector tip seal.
    • Apply engine oil to the injector O-ring.
    • Do not use the dropped part.
    • When inserting the injector, be careful not to damage the end of the injector.
      G15557083Courtesy of HYUNDAI MOTOR AMERICA
    • When inserting the support disc, inserting the support disk so that the slanted surfaces are in contact with each other.
      G15557084Courtesy of HYUNDAI MOTOR AMERICA

    [MPI Injector]Β 
    • Do not reuse the used injector O-ring.
    • Apply engine oil to the injector O-ring.
    • When inserting the injector, be careful not to damage the injector tip.
      G15557085Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.