Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Genesis G70 2.0T Advanced, AWDFACTORY OEM SERVICE PROCEDURE
TCM terminal function
| Pin | Description | Pin | Description |
|---|---|---|---|
| 1 | Underdrive Clutch control solenoid valve | 40 | Back UP Comm. (TCM→Electronic shift lever) |
| 2 | Damper clutch control solenoid valve | 43 | CAN HIGH |
| 3 | 27 Brake control solenoid valve | 44 | CCP CAN LOW |
| 5 | 6 Clutch control solenoid valve | 45 | D position solenoid valve (ON/OFF) |
| 7 | Line pressure control solenoid valve | 49 | Parking switch ground |
| 8 | 35R Clutch control solenoid valve | 52 | CAN LOW |
| 9 | 4 & OD Clutch control solenoid valve | 53 | CCP CAN HIGH |
| 10 | 8LR Brake control solenoid valve | 54 | P position solenoid valve (ON/OFF) |
| 12 | Back UP Comm. (TCM→Electronic shift lever) | 55 | Back-up lamp relay |
| 14 | Parking switch signal "S2" (PWM) | 56 | Output speed sensor (power), 9V |
| 15 | Parking switch power (5V) | 58 | Input speed sensor (power), 9V |
| 18 | R position solenoid valve (ON/OFF) | 65 | Solenoid valve power 1 (UD, 27, 8LR, DC) |
| 20 | Paddle shift (Down) | 66 | Solenoid valve power 2 (4 & OD, 35R, 6C, LP) |
| 21 | Paddle shift (Up) | 67 | Power (VB) |
| 22 | Parking switch signal "S1" (PWM) | 68 | Power (VB) |
| 24 | P/N relay | 70 | Solenoid valve power 3 (ON/OFF) |
| 25 | Oil temperature sensor (+) | 71 | Ground |
| 26 | Oil temperature sensor (-) | 72 | Solenoid valve power 4 (ON/OFF) |
| 27 | Back UP Comm. (TCM→Electronic shift lever) | 73 | Ground |
| 31 | Input speed sensor signal | 74 | Ground |
| 32 | Output speed sensor signal | - | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
