2019 Genesis G70 2.0T Advanced, AWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Perform the oil pressure characteristics backup procedure using the KDS when replacing with a new TCM.
    G13540082Courtesy of HYUNDAI MOTOR AMERICA
    G13540083Courtesy of HYUNDAI MOTOR AMERICA
    G13540084Courtesy of HYUNDAI MOTOR AMERICA
    G13540085Courtesy of HYUNDAI MOTOR AMERICA
    G13540086Courtesy of HYUNDAI MOTOR AMERICA
    G13540087Courtesy of HYUNDAI MOTOR AMERICA
  2. Disconnect the TCM connector (A).
    G13540088Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the TCM (A) after loosening the nuts.
    G13540089Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.